Mood light v2.0
From uCtrl.net
Contents |
Information
A RGB Prolight LED mounted in a heat-sink, four rubber feet holds the glass ball (or rock) over the LED. Everything that can be illuminated from the bottom can be used. The LED has a effect of 3 watts and emits up to 30 lumen in 140 degrees. The LED uses 350mA, and a heat-sink must be used. The light is so intense that one should not look directly into ray of light.
Controller
The Prolight LED is controlled by AVR ATMega8. See Mood light controller v1.1 for more information.
Parts list
| Quantity | Supplier | Part number | Description |
| 4 | Elfa | 48-866-02 | Rubber Foot, adhesive, SJ-5027, Ø16x7.9 |
| 1 | Elfa | 75-646-77 | Heat conducting film for heatsink, Adhesive, TO220 |
| 1 | LED1.de | 4402 | Heatsink Prolight, 50x48x17mm, size 2 |
| 1 | Elfa | 48-351-20 | Terminal block, pluggable, 3.5 mm, 4-pin skrew female |
| 1 | LED1.de | 2000000001 | LED Prolight, RGB, 3W, 2.2 3.3 3.4V, 350mA, 140° |
| 1 | Elfa | 55-722-35 | Control cable 4-cores, 0,25mm2, 14x0,15mm 250 V, Ø 4,6mm |
| 2 | LED1.de | 2511000 | Resistor 5% 1W, 5,1 Ohm |
| 1 | LED1.de | 2821000 | Resistor 5% 1W, 8,2 Ohm |
Images
 Glass ball, no light |
 Glass ball, blue/green light |
||
Glass ball |
|||
 Mood lamp connector |
